How Do You Reset The Anti-Theft System On A Chevy Equinox?

You may not be a car enthusiast, but you know that your Chevy Equinox is much more than just a means to get you from point A to point B. You love the safety features, sleek design, and comfortable interior.

But, you haven’t understood how the anti-theft system work, hence your question – how do you reset the anti-theft system on a Chevy Equinox?

How Do You Reset The Anti-Theft System On A Chevy Equinox?

Turn the key switch between ACC AND O (the middle notch) and press the reset button(RES) on steering wheel, and the light will go off then you will likely need to perform a proper jump, and the car will work fine.

Product Recommendations:

How Do I Get My Car Out Of Anti-Theft Mode?

Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car.

Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

Step 3: Open and close your driver’s side door six times within 10 seconds. This will reset your car’s computer and should turn off your anti-theft system.

Step 4: Turn your vehicle’s ignition switch to “On” without starting your engine. This will allow your car to connect with its internal computer again and allow it to register that your anti-theft system has been disabled. Turn it off once this is complete.

Step 5: Reinsert your physical key into the driver’s side door lock and turn it from “Lock” to “Unlock” quickly five times within 10 seconds. You should get a confirmation tone when you have completed this step successfully, which means that you have unlocked your anti-theft system.

Why Does MChevy Equinox Say Theft Attempted?

The Chevy Equinox has several different measures to prevent theft. There is a switch in the ignition lock that deactivates the fuel pump if it is turned off during operation. This prevents the engine from running.

There is a Passlock system that is a part of the body control module (BCM). It uses the key to send a signal to the BCM to tell it that the key is in use. The BCM then sends a signal to the power control module (PCM) that allows fuel delivery and spark. If there is any problem with this communication, the PCM will disable fuel delivery and spark, preventing the car from starting.

The message Theft Attempted simply means there was an interruption in this communication. If you have another key, try using it to start your vehicle. Alternatively, you can try disconnecting your battery for 10 minutes then reconnecting it and trying again, but don’t do that if you have a keyless entry system or an alarm system as it will reset them and will require reprogramming after reconnection.

Will Disconnecting Battery Reset Anti-Theft?

According to a car user:

I have a 2002 Hyundai Accent. The anti-theft light is blinking on the dash. I did disconnect the battery, but when I reconnected it, the light is still blinking. Is there another way to reset the anti-theft?

If your car has an anti-theft module and you disconnect the battery it will not reset the system (it’s not like rebooting your computer). You’ll need to find out where the anti-theft module is located and disconnect or remove the fuse for it. Your owner’s manual may tell you where it’s located but if you don’t have one then check with a dealer or mechanic who can read your codes.

Once that module is out of commission, you should be good to go.

Is There A Fuse For Anti-Theft System?

The anti-theft fuse is located in the under-hood fuse panel. Refer to the Owner’s Guide for location information. You can also find a diagram of the fuse panel layout in your owner’s manual.

How Do I Get My Car Out Of Anti-Theft Mode Without Remote Or Key?

The first and foremost thing to do is get your car’s remote and key transmitter working again. Without the remote, you’re probably going to be stuck with some serious challenges. And we mean serious!

The simplest solution is to replace the battery in your car’s remote. The problem with this, of course, is that you will need a new battery. For some people, this might be a problem since they can’t afford it. Still, this isn’t something you should worry about too much because a new battery usually costs less than $10, which is not a lot of money at all.

If this doesn’t work, then there are some other options for getting your car out of anti-theft mode without remote or key. You can try using a jump start or even a tow truck to get your vehicle moving again. This is one of the easiest ways to get it out of the anti-theft mode but it does come with a few disadvantages as well including:

There’s no way for you to know where your car has been towed and if it’s safe enough for you to drive back home or not (this can be dangerous). A tow truck will cost more money than just replacing the remote itself (and they aren’t cheap either).

What Does Flashing Car With Key Mean?

When the key symbol flashes it means that there is a problem with the immobilizer system in the car.

The immobilizer system is connected to the engine control unit and prevents an unauthorized person from starting the car. If it is flashing this means that there is a problem and you won’t be able to start your vehicle.

You were able to start your car by disconnecting and reconnecting the battery because this “reset” the immobilizer system. However, if you drive for any length of time and turn off the ignition for more than a few seconds, this fault will come back.

How Do You Reset The Anti-Theft System On A Chevy Equinox – Conclusion

As a recap of the response we gave to the question, How Do You Reset The Anti-Theft System On A Chevy Equinox?

Turn the key switch between ACC AND O (the middle notch) and press the reset button(RES) on steering wheel, and the light will go off then you will likely need to perform a proper jump, and the car will work fine.

Thanks for reading.

Similar Posts